Suria KLCC

(Suria KLCC) Fit Out Guidelines - Mall Requirements for Hoarding, Visual & Reinstatement

20 April 2025

Share This Post

DISCLAIMER: Please note that these guidelines may change without prior notice; we will do our best to update the information as frequently as possible. The information below is intended for your reference only.

For the most accurate and detailed information, please contact the mall's fit-out team directly.

Mall's Name: Suria KLCC

Mall's Co.Name: Suria KLCC Sdn Bhd

Location: Kuala Lumpur

HOARDING & VISUAL (Indoor Lot & Kiosk) REQUIREMENTS

1.	Hoarding Material	MDF	NOTES: Marine Plywood (Proposed Material If Outdoor Hoarding - Expose to Weather)
2.	Hoarding Structure	Timber
3.	Hoarding Door Type	Sliding Door	1500mm x 2100mm
4.	Add-On (Counterweight)	a. For Kiosk (Free-Stand) b. Outdoor hoarding (Expose to Wind Load) c. Hoarding Height exceed 5meter
5.	Add-On (Fabric)	Top Fabric Surface Cover	For Lot & Kiosk
6.	Hoarding (Kiosk) Height	Phase 1: 1220mm (4ft) with Top Surface Fabric Cover Phase 2: Remove Top Surface Fabric & Install Top Vertical Fabric with Timber Structure till Ceiling Height	Clarification: KLCC management don't want the hoarding to block the view too long for other tenants. When your team doing the kiosk flooring platform, the hoarding height of 4ft only can cover with TOP SURFACE FABRIC. Then when your team want to start building the kiosk structure, then only can replace top surface fabric with VERTICAL FABRIC.
6.	Hoarding Visual Material	Sticker Only	By Mall Panel Only
7.	Skirting	2inch (Bottom Only)

NOTES: Click HERE for sample hoarding and/or visual installation at Suria KLCC for your reference

MALL FIT OUT GUIDELINES

1.	Safety Pledge	Valid for 3 months NOTES: Compulsory for all site personnel & workers to attend safety briefing at security office to obtain safety pledge before start work on-site. Set appointment prior before attending the safety briefing.
2.	Site Dilapidation Picture(s)	Make sure take pictures of existing site condition before start work to avoid any dispute later.
3.	Floor Protection On-Site	Compulsory installation of floor protection at common walkway area for trolleys & workers mobilization during on-site work and clear off & clean up on daily basis after daily job done.
4.	CIDB Green Card	Worker(s) compulsory to have CIDB Green Card in order to work within the mall.
	Aluminium Scaffold (BS SCAFFOLD)	For on-site worker(s) to access WORK AT HEIGHT, it is compulsory under mall safety requirement to use ALUMINIUM SCAFFOLD with GREEN TAG tagging which inspect by AUTHORIZED & COMPETENT SCAFFOLD INSPECTOR.

REINSTATEMENT GUIDELINES

1.	Preliminaries	Site Arrangement & Documents Preparation
2.	Insurance	RM2mil Public Liability
3.	Reinstatement	Dismantle, Demolish, Move Out, Clear Off
4.	Rorobin (RRB)	Engage by Contractor(s), To Clear Out from Mall Loading Bay Area before 6am Daily (STRICTLY NO OVERNIGHT)
5.	3rd Party Panel Contractor(s)	a. Sprinkler b. Wet Chemical (If Have, for F&B Lot/Kiosk Only) c. LPG (If Have, for F&B Lot/Kiosk Only) d. Telephone Line e. PA Speaker f. Flushing (If Have Floor Trap within the Lot/Kiosk) g. Tiles Replacement (Supply & Install)
6.	Touch Up and/or Restoration	After Site Inspection by Mall Fit Out Team (IF REQUIRED ONLY based on Lot Condition)Frequent Restoration Item(s) as Listed Below: 1. Wall (Skim, Plastering & White Painting) 2. Ceiling (Plastering & Painting) 3. Tiles Replacement Lease Line Area (by Mall Panel Only) 4. Internal Lot Pelmet Close Up using Gypsum Board 5. Floor Tiles/Marble Polishing 6. Sprinkler (Level 1 - Paint RED) 7. Telephone Box (To Replace / Relocate Back to Original) 8. Isolator (To Replace / Relocate Back to Original)